Honeywell RPWL800A1002/W Owner's Manual - Page 10

Installation and Use Installing the receiver Receiver operation When the call button is pressed on the door camera, the receiver chimes (provided the volume switch is not set to 0) and the camera image is displayed for about thirty seconds. If the caller presses the call button again, then the display time will extend to another 30 seconds. Video transmission is limited to 30 seconds to conserve cam- era battery life and is not adjustable. When the batteries need recharging, a MIC VOLUME [FOR FUTURE USE] camera image is no longer shown - the chime alone sounds (unless the battery DISPLAY BRIGHTNESS level is too low for sound). Charging base CHIME VOLUME Like a portable phone, keep the receiver topped up on the charging base for reliable operation. Depending on use, the receiver should operate for several days off the charging base. The charging base can be used on a flat surface or mounted to a wall using the supplied screws and wall plugs. Before mounting in place, check that the receiver can pick up a good signal at the intended position. Battery indicator The indicator behaves as follows: Remains on when the receiver is on the charging base and is fully charged. Blinks once a second when the receiver is charging. Remains off when the receiver is off the charger and the batteries are OK. Blinks slowly once every ten seconds when the receiver is off the charging base and needs recharging. Chime flasher Flashes to indicate a call when the chime volume control is in position 0 or 2*. Display brightness Activate the door camera by pressing its call button, then adjust the receiver display for best viewing by using the four position slide switch. One step down from maximum brightness is the recommended setting. Chime volume control The chime volume level can be set to using the lowest slide switch of the three (see diagram above). Adjust to high level (2), low level (1), or off (0). 69-2108EFS-01  69-2108EFS_A.indd 8 11/30/2007 1:51:48 PM