Honeywell RPWL800A1002/W Owner's Manual - Page 5
Charge the receiver batteries, leave the unit to charge, for at least three hours, Program the door
UPC - 085267334310
View all Honeywell RPWL800A1002/W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Pre-installation setup Charge the receiver batteries 1. Remove the battery isolating tab at the rear of the portable receiver. 2. Place the receiver onto the charging base and plug the charging base into a suitable mains socket. The battery indicator flashes slowly if this is the first time the unit has been powered up; the chime tunes play once the batteries have enough power. Before the next step, leave the unit to charge 1 for at least three hours so that the batteries have enough power for the LCD screen. The receiver takes about 12 hours to be fully charged. Note that the charging base and rear of the receiver will get warm in use: this is normal. VISIOCAM 2 Program the door camera into the receiver Ensure the door camera and receiver are separated by at least 6 ft. (2 m). To program the door camera into the receiver, press and hold the call button on the door camera until the receiver responds with a tune and displays the image captured by the camera. Once the door camera has been programmed into the receiver, the receiver remains active in program mode for approximately two minutes. Note: You can select another tune by pressing the ' ' button. 69-2108EFS_A.indd 3 69-2108EFS-01 11/30/2007 1:51:45 PM