Honeywell RPWL800A1002/W Owner's Manual - Page 13
Expanding your system
UPC - 085267334310
View all Honeywell RPWL800A1002/W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Expanding your system VISIOCAM There are many ways to expand your entry system: you can connect your system to a television set or add more cameras, for example. TV connection You can connect the receiver to a TV set via the accessory RCA lead provided. Connect the stereo plug to the VisioCam receiver unit and plug the yellow RCA plug to the TV AV input. Set the TV channel to the default AV channel for the said RCA input (refer to TV set instructions). When the door camera is activated, the VisioCam receiver will chime and the TV will display the image of the visitor. Note: The TV needs to be set at the default channel manually in order to display the image. Auto switching function not available. Adding a door push The receiver will respond to a Visiocam door push. To program a door push into the receiver: 1. Press and hold the ' ' button for approximately five seconds until the receiver beeps three times 2. Press the door push button until the receiver sounds. Note: The video receiver does not respond to a door push while the video screen is active. Additional door cameras The receiver will respond to up to four door cameras. Each camera must be set on a different video channel (1-4), and be programmed into the receiver. Refer to the instructions provided with the additional unit, or see 'To reprogram or reset the receiver', in this section. To reprogram or reset the receiver A. To add another door camera or bell push: Press and hold the ' ' button for more than five seconds, the unit will beep three times and enter programming mode for approximately two minutes. During the two minute programming time, press the call button or button on the new unit to program it in. The unit must be within 30-60 ft. (10-20 m) of the receiver to ensure reliable programming. B. To clear all programmed data, e.g. when replacing a door camera: Press and hold both the ' ' and ' ' buttons in for five seconds to clear the programmed data and enter programming mode. The available chime sounds play. Follow the programming sequence under Receiver Setup. 69-2108EFS_A.indd 11 11 69-2108EFS-01 11/30/2007 1:51:49 PM