Honeywell W8735B Owner's Manual - Page 4
Telephone Access Module Description, Indicators, Pass Code Reset Button
View all Honeywell W8735B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
TELEPHONE ACCESS MODULE DESCRIPTION Indicators The three light emitting diode (LED) indicators, see Fig. 1, on the front panel illuminate to provide information about the battery, auxiliary input, and phone line status: battery auxiliary input STATUS LEDs BATTERY AUXILIARY INPUT ON LINE on line momentary flash - ok on steady flash continuously - replace replace M14812 Fig. 1. Status LED indicators. • battery - When the battery is good, the LED flashes momentarily once every ten seconds. When the battery is weak, it flashes with a steady pulse; when the battery is dead (or not installed), the battery LED is on continuously. IMPORTANT: If the battery indicator is on continuously or indicates a steady flash, replace the battery immediately (see Battery Installation section). Replace the battery annually and/or 60 70 80 90 before leaving for an extended period 60 70 80 90 of time. • auxiliary input - If an auxiliary sensor is connected and has tripped, the auxiliary input LED illuminates. IMPORTANT: Determine the cause of the sensor trip and resolve immediately. • on line - When the Telephone Access Module answers the phone line or is in the process of dialing out an alert message, the on line LED illuminates. Pass Code Reset Button If you have forgotten your Pass Code, use the reset button to reset the Pass Code to the original factory setting of 1 2 3 4. To reset the Pass Code, Fig. 4, to the factory setting, press and hold the reset button for five seconds. After five seconds, all three LEDs flash once. 69-1353 4