Hoover F5807 Manual - Page 11

Using the stair/upholstery nozzle Some models come with a hose and stair/upholstery nozzle. How to attach hose Disconnect deep cleaner from electrical outlet. SOLUTION TUBE TANK HANDLE To prevent possible leaking, remove clean solution tank by pressing down on tank handle and pulling forward; set tank aside (do not set tank on furniture). Remove hose from storage rack. Before connecting tube to cleaner, make sure black tabs are extended by pulling tan collar toward tube. Open door on hood labeled "Stair/Upholstery Cleaning Connection". Press round solution tube connector onto round projection inside door. Press connector collar down firmly to ensure that it is fully connected. HANDLE RELEASE PEDAL Step on handle release pedal and lower deep cleaner handle until it rests on the floor. Unlatch back part of recovery tank lid and remove lid. TABS FRONT FRONT PANEL Remove recovery tank front panel by sliding it straight up. The tank lid replaces in a hinge-like manner. Position front of lid under tabs on front of tank. Rotate lid down onto tank. Make sure lid is secure on all sides before cleaning. For full suction, it is important that the recovery tank lid is properly secured before cleaning. Reverse procedure to remove hose and solution tube. Raise deep cleaner handle to upright position. TAB CONVERTER LATCH Replace panel with converter. Slide converter halfway down opening until it is firmly in place. Attach nozzle to connector end of hose by sliding it onto connec- tor until the tab locks it securely. Using your thumb, push forward and up on the latch to remove nozzle. Follow the instructions on pages 12 and 13 for the appropriate cleaning task. Using stair/upholstery nozzle 11