Hoover F5807 Manual - Page 3

Assembling deep cleaner Assembled models without Assembled models with 4 attached tools will look like attached tools will look this drawing. like this drawing. Push bolts into holes on front of handle (Fig. 4). If bolts will not go through hole easily handle is not pushed completely down. 5 Attach upper handle 1 2 Place nuts in recessed areas on back of handle. Hold each nut in place while tightening each bolt securely with a Phillips screw driver (Fig. 5). Only two nuts are needed on this model. The extra nut is not (B) required but has been provided for your convenience. 6 Remove clean solution tank (upper tank) (Fig. 1). Remove nozzle stored on upper handle by gently pushing nozzle downward while pivoting it away from the handle at (B). 3 SQUEEZE TRIGGER When handle sections are completely together, squeeze trigger on upper handle to snap trigger rod in place (Fig. 6). 7 CORD HOOK TANK HANDLE With cord hook to back of deep cleaner, push upper handle down onto lower handle. (Fig.3). Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place (Fig. 7). Continued § Assembly 3