Hotpoint GSM1800NBB Installation Instructions - Page 12
Installation Instructions, WARNING - review
View all Hotpoint GSM1800NBB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installation Instructions STEP 14 CONNECT POWER SUPPLY Skip this step if equipped with power cord. Verify that power is turned off at the source. • Remove junction box cover "A". • Locate the three dishwasher wires, (white, black and green) with stripped ends. Insert dishwasher wires through the small hole in the junction box "B". • Secure house wiring to the bottom of the junction box with a strain relief "C". • Use wire nuts to connect incoming ground to green, white to white and black to black "D". • Replace junction box cover "E". Check to be sure that wires are not pinched under the cover. A Remove Junction Box Cover B Check That White, Black and Green Dishwasher Wires Are Threaded Thru Hole in Back Ground White Black D Use UL Listed Wire Nuts Figure Y C Insert Power Cord Wires Thru Strain Relief and Tighten E. Replace Junction Box Cover WARNING If house wiring is not 2-wire with ground, a ground must be provided by the installer. When house wiring is aluminum, be sure to use UL Listed anti-oxidant compound and aluminumto-copper connectors STEP 15 PRE-TEST CHECKLIST Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty. Check to be sure power is OFF. Open door and remove all foam and paper packaging. Locate the Owner's Manual in the literature package. Read the Owner's Manual for operating instructions. Check door opening and closing. If door does not open and close freely or tends to fall, check spring adjustments. See Step 1. Check to be sure that wiring is secure under the dishwasher, not pinched or in contact with door springs or other components. See Step 9. Check door alignment with tub. If door hits tub, level dishwasher. See Step 10. Pull lower rack out, about half way. Check to be sure it does not roll back or forward on the door. If the rack moves, adjust leveling legs. See Step 10. Check door alignment with cabinet. If door hits cabinet, reposition or relevel dishwasher. See Step 10. Verify water supply and drain lines are not kinked or in contact with other components. Contact with motor or dishwasher frame could cause noise. See Step 8. Turn on the sink hot water faucet and verify water temperature. Incoming water temperature must be between 120°F and 150°F. A minimum of 120°F temperature is required for best wash performance. See "Prepare Hot Water Line," page 5. Add 2 quarts of water to the bottom of the dishwasher to lubricate the pump seal. Turn on water supply. Check for leaks. Tighten connections if needed. Remove protective film if present from the control panel and door. 11