Hotpoint RB757WHWW User Guide - Page 38

Installation Instructions 3 POWER CORD AND STRAIN RELIEF INSTALLATION A Remove the wire cover (on the lower back of the range) by removing two (2) screws using a 1/4" nut driver. Do not discard these screws. 2 screws to remove wire cover Retaining tab C For power cord installations only (see the next step if using conduit), assemble the strain relief in the hole. Insert the power cord through the strain relief and tighten. Allow enough slack to easily attach the cord terminals to the terminal block. If tabs are present at the end of the winged strain relief, they can be removed for better fit. NOTE: Do not install the power cord without a strain relief. The strain relief bracket should be installed before reinstalling the rear range wiring cover. Terminal block Back of range Wire cover B Remove the knockout ring (13⁄8″) located on bracket directly below the terminal block. To remove the knockout, use a pair of pliers to bend the knockout ring away from the bracket and twist until ring is removed. Terminal block (appearance may vary) Strain relief Power cord Skip to Step 4 or 5. Bracket D For conduit installations only, purchase a squeeze connector matching the diameter of your conduit and assemble it in the hole. Insert the conduit through the squeeze connector and tighten. Allow enough slack to easily attach the wires to the terminal block. NOTE: Do not install the conduit without a squeeze connector. The squeeze connector should be installed before reinstalling the rear range wiring cover. Knockout ring in bracket Knockout ring removed 37 Squeeze connector Conduit Skip to Step 6 or 7. Terminal block Bracket