Hunter 21623 Owner's Manual - Page 17
Maestro™ and Remote Continued
View all Hunter 21623 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
10 • Installation and Setup of Maestro™ and Remote (Continued) Powering the Maestro™: AC Adaptor 10-1.Plug the AC adaptor into the back of the Maestro™ in the port labeled power. Maestro™ 10-2.Select the correct channel by sliding the switch to the desired channel. For 3.5mm Stereo Cable Installation: 10-3.Plug a 3.5mm stereo cable into the back of the Maestro™ in the port labeled line in. 10-4.Plug the other end of the 3.5mm stereo cable into your audio device. For Speaker Wire Installation: 3.5mm Stereo Cable 10-5.Connect the speaker wire (not included) to the speaker input terminals on the bottom of the Maestro™. Make sure that the plus (+) and the minus (-) signs on the Maestro™ correspond with the plus (+) and the minus (-) signs on your audio device. 10-6.Make sure that all connections are firm. NOTE: Contact between bare speaker wires at the terminals can cause a short-circuit. 10-7.Install the included 3-volt battery into the transmitter This product includes one 3-volt type CR2025 battery for use with the remote control transmitter. Please contact your local battery recycling center for proper battery disposal information. CAUTION: The remote control device complies with part 15 of the FCC rules. Changes or modifications not expressly approved by Hunter Fan Company could void your authority to operate this equipment. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. DO NOT put Maestro™ in a damp place or where humidity is high. NOTE: For Optimal Performance. Place the Maestro™ at least 5' away from all wireless devices. 17 45049-01 • 07/13/09 • Hunter Fan Company