Hunter 23921 Owner's Manual - Page 10
Warning, Attaching The Switch Housing Gasket, And Upper Switch Housing, Caution
View all Hunter 23921 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
7 • Completing Your Installation With a Bowl Light Fixture Your Hunter fan comes with an integrated light fixture assembly. WARNING: Use only the light fixture supplied with this fan model. The switch housing assembly is made up of three sections: the switch housing gasket, the upper switch housing, and the lower switch housing/ light assembly. ATTACHING THE SWITCH HOUSING GASKET AND UPPER SWITCH HOUSING 7-1. Locate the switch housing mounting plate, the switch housing gasket and the upper plug connector as shown. NOTE: Your fan may come with the switch housing gasket attached to the switch housing mounting plate. If the switch housing gasket is attached to the switch housing mounting plate, go to the section "Attaching the Upper Switch Housing." If the switch housing gasket is not attached complete the steps below. 7-2. Identify the top side of the switch housing gasket by looking for the raised circular ridge on the gasket. 7-3. With the top side of the switch housing gasket facing up towards the motor, align the holes in the gasket with the spokes on the switch housing mounting plate. 7-4. Feed the upper plug connector through the center opening of the upper switch housing. Push the gasket up so that it is seated flush with the mounting plate . Gasket Step 7-1 Holes Step 7-3 Mounting Plate Upper Plug Spokes CAUTION: Make sure the upper switch housing is securely attached to the switch housing mounting plate. Failure to properly attach and tighten all three assembly screws could result in the switch housing and light fixture falling. Upper Switch Housing Step 7-4 Upper Plug 10 42786-01 • 08/14/09 • Hunter Fan Company