Husqvarna 550 XP G Mark II Owner Manual - Page 14
To stop the product, Pull stroke and push stroke, To use the cutting technique, CAUTION, WARNING
View all Husqvarna 550 XP G Mark II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
5. Pull the starter rope handle quickly and with force. Pull stroke and push stroke You can cut through wood with the product in 2 different positions. • To cut on the pull stroke is when you cut with the bottom of the guide bar. The saw chain pulls through the tree when you cut. In this position you have better control of the product and the position of the kickback zone. CAUTION: Do not pull the starter rope to full extension and do not let go of the starter rope handle. This can cause damage to the product. a) If you start your product with a cold engine, pull the starter rope handle until the engine fires. Note: You can identify when the engine fires through a "puff" sound. b) Disengage the choke. 6. Pull the starter rope handle until the engine starts. 7. Quickly disengage the throttle trigger lockout to set the product to idle speed. • To cut on the push stroke is when you cut with the top of the guide bar. The saw chain pushes the product in the direction of the operator. 8. Move the front hand guard rearward to disengage the chain brake. WARNING: If the saw chain is caught in the trunk, the product can be pushed at you. Hold the product tightly and make sure that the kickback zone of the guide bar does not touch the tree and causes a kickback. 9. Use the product. To stop the product 1. Push the start/stop switch down to stop the engine. To use the cutting technique WARNING: Use full throttle when you cut and decrease to idle speed after each cut. 14 544 - 005 - 10.05.2019