Husqvarna AUTOMOWER 450X EPOS Owner Manual - Page 33

6.4 LED indicator lamp on the charging station For a fully functional installation, the indicator lamp in the charging station must show a solid or flashing green light. If another color shows, follow the troubleshooting guide below. There is more help on www.husqvarna.com. If you still need help, speak to your local Husqvarna representative. Light Status Green solid light Good signals. Green flashing light The signals are good and ECO mode is activated. Refer to ECO mode on page 19. Red flashing light Interruption in the charging station's antenna. Speak to your local Husqvarna representative. Red solid light Fault in the circuit board or incorrect power supply in the charging station. The fault must be correct by an authorized service technician. Speak to your local Husqvarna representative. 6.5 LED indicator on the product The LED indicator on the control panel of the product shows the current product status: LED indicator light Product status Constant green Flashes green The product cuts the lawn or moves out of the charging station. The product is in Pause mode. Flashes red The product stopped because of an error. Constant yellow The STOP button was pushed. Flashes yellow The PIN code must be entered to start the product. Constant blue The product moves to the charging station or a maintenance point. An app is connected to the product with Bluetooth®, the LED indicator is constant blue for 3 seconds. Pulsates blue The product charges in the charging station. Flashes blue The product is parked in charging station. The product can at this time find Bluetooth® and connect with Bluetooth®. Constant white The product is in appDrive mode. Pulsates white The product sets to OFF. Firmware installation is in progress. Flashes white New firmware must be installed. There is more information on www.husqvarna.com. Speak to your local Husqvarna representative for more information. 1970 - 001 - 10.10.2022 Troubleshooting - 33