Husqvarna MZ 5225 Owners Manual - Page 44
Deck belt, Deck belt removal, Deck belt installation
View all Husqvarna MZ 5225 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
MAINTENANCE Deck belt Deck belt removal Park on a level surface. Apply park brake.Lower the deck into the lowest cutting position. 1. Remove foot plate and belt shields. 2. Using a ratchet with a 9/16" socket on the spring idler bolt to relieve the tension on the belt. 3. Remove any dirt or grass that may have accumulated around the cutter housings and entire deck surface. 4. Carefully roll the belt over the top of the cutter housing pulleys. 5. Remove the belt from around the electric clutch on the engine shaft. 6. The belt can now be removed. Slackening the belt tensioner Deck belt installation NOTE: For ease in installing the deck belt, refer to the routing decal on bottom of seat. 1. Wrap the deck belt around the electric clutch pulley that is located on the engine shaft. 2. Route the belt forward between and up onto the deck. 3. Place belt around spring loaded idler pulley. 4. Wrap the belt around the stationary idler 1 pulley and around the mandrel housings. 5. Push inward on the idler arm and carefully route belt over stationary idler pulley. Once belt is properly routed, slowly release idler arm to tension belt. 6. Double check belt routing to make sure it matches the routing decal, and the belt does not have any twist. Correct as needed. 2 7 4 6 3 7. Adjust tension. 8. Replace belt shields on both mandrel housings and secure with fasteners. 5 Belt routing, deck belt 8011-622 8011-580 English-44