IBM 849130u Installation Guide - Page 17

Major, components, server

Get IBM 849130u - Servers X Series P-4 3.2ghz PDF manuals and user guides
UPC - 000435947147
View all IBM 849130u manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Major components of the server Blue on a component indicates touch points, where you can grip the component to remove it from or install it in the server, open or close a latch, and so on. Orange on a component or an orange label on or near a component indicates that the component can be hot-swapped, which means that if the server and operating system support hot-swap capability, you can remove or install the component while the server is running. (Orange can also indicate touch points on hot-swap components.) See the instructions for removing or installing a specific hot-swap component for any additional procedures that you might have to perform before you remove or install the component. The following illustration shows the major components in the server. Note: The illustrations in this document might differ slightly from your hardware. Riser-card Assembly DIMM Heat sink Air baffle Air deflector Fans CD/DVD drive SAS/SATA controller (some models) System board SAS/SATA backplane (some models) SATA simple-swap back panel (some models) Power supply Hot-swap hard disk drive (some models) SAS filler Fans SATA filler Bezel Simple-swap SATA hard disk drive (some models) Attention: Do not remove the air deflector unless directed to do so in this publication or by IBM Service. Chapter 1. Introduction 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
Major
components
of
the
server
Blue
on
a
component
indicates
touch
points,
where
you
can
grip
the
component
to
remove
it
from
or
install
it
in
the
server,
open
or
close
a
latch,
and
so
on.
Orange
on
a
component
or
an
orange
label
on
or
near
a
component
indicates
that
the
component
can
be
hot-swapped,
which
means
that
if
the
server
and
operating
system
support
hot-swap
capability,
you
can
remove
or
install
the
component
while
the
server
is
running.
(Orange
can
also
indicate
touch
points
on
hot-swap
components.)
See
the
instructions
for
removing
or
installing
a
specific
hot-swap
component
for
any
additional
procedures
that
you
might
have
to
perform
before
you
remove
or
install
the
component.
The
following
illustration
shows
the
major
components
in
the
server.
Note:
The
illustrations
in
this
document
might
differ
slightly
from
your
hardware.
Riser-card
Assembly
SAS/SATA controller
(some models)
System board
SAS/SATA
backplane
(some models)
SATA simple-swap
back panel (some models)
Power supply
Fans
Simple-swap SATA
hard disk drive
(some models)
SATA filler
Bezel
Hot-swap
hard disk drive
(some models)
CD/DVD
drive
Fans
SAS filler
Air baffle
Air deflector
Heat sink
DIMM
Attention:
Do
not
remove
the
air
deflector
unless
directed
to
do
so
in
this
publication
or
by
IBM
Service.
Chapter
1.
Introduction
5