IBM 9511HG2 User Guide - Page 12
Manual Setup
UPC - 087944573609
View all IBM 9511HG2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
ENGLISH FRANÇAIS DEUTSCH U65C`tfuvq/cbdlvq/gn Qbhf 24 Xfeoftebz- Kvmz 23- 3111 5;1: QN Manual Setup If the monitor is in standby mode (STANDBY ON), it might automatically turn off while you are waiting for it to warm up. The size and diversity of the dot pattern varies with the screen resolution. Normally, you can complete the setup procedure using AUTO SETUP, however, if your screen image is still distorted after you perform AUTO SETUP or the setup diskette does not run on your system, perform MANUAL SETUP. 1. Have your monitor turned on for about 15 minutes, until the monitor warms up. 2. Display the image you most frequently use on the screen. 3. Press the OSD Enter button the initial OSD menu. at the bottom of the monitor to display 4. Use an Arrow button ( or ) to select the IMAGE LOCK icon and press the OSD Enter button to access the function. 5. Using an Arrow button ( or ), select MANUAL, press and then press once to select COARSE. Left and right arrow adjustment indicators become illuminated (see page 17). 6. Use the Arrow buttons to manually adjust to correct (as much as possible) for noise in the video signal then press to save the changes. 7. Use an Arrow button to select FINE and press the button. 8. Use the Arrow buttons again to tune the image to your liking. 9. When finished, press the Exit button OSD. four times to exit from the You have completed the monitor setup. ESPAÑOL ITALIANO JAPANESE COMPL & WARR 13