Icom IC-M400BB Instruction Manual - Page 17

Microphone installation

Get Icom IC-M400BB PDF manuals and user guides View all Icom IC-M400BB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

4 CONNECTIONS AND MAINTENANCE ■■Microphone installation The HM-195 should be connected to the transceiver using the supplied OPC-1540 connection cable. The cable is used to operate from a longer distance. The cable connector can also be installed as a built-in plug on a cabinet or wall. To operate from even longer distances, the optional 6 meter long OPC-1541 extension cable can be used between the transceiver and the OPC-1540. Up to two OPC-1541 can be added. DDInstallation qqInsert the OPC-1540 cable connector into the command microphone jack, and tighten the nut. wwTo use the cable connector as a wall socket, install it as described to the right. 1 eeUsing the mounting base as a template, carefully mark the 2 holes where the cable and three screws will be fastened. 3 rrDrill holes at these marks. ttInstall the mounting base using the supplied screws, as 4 shown below. 5 Mounting base Nut 6 7 8 Gasket 9 10 Screw holes (approximately 2 mm; 3⁄32˝ (d)) Cap 11 yyThe completed installation should look like this. 12 13 14 15 16 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
9
4
CONNECTIONS AND MAINTENANCE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Microphone installation
■
The HM-195 should be connected to the transceiver using
the supplied OPC-1540 connection cable. The
cable is used
to operate from a longer distance. The cable connector can
also be installed as a built-in plug on a cabinet or wall.
To operate from even longer distances, the optional 6 meter
long OPC-1541 extension cable can be used between the
transceiver and the OPC-1540. Up to two OPC-1541 can be
added.
Installation
D
Insert the OPC-1540 cable connector into the command
q
microphone jack, and tighten the nut.
To use the cable connector as a wall socket, install it as
w
described to the right.
Using the mounting base as a template, carefully mark the
e
holes where the cable and three screws will be fastened.
Drill holes at these marks.
r
Install the mounting base using the supplied screws, as
t
shown below.
Gasket
Cap
Mounting base
Nut
Screw holes
(approximately 2 mm;
3
/
32
˝ (d))
The completed installation should look like this.
y