Icom ID-52A Instructions 2 - Page 5

Operation Cropping a picture 1. Touch the black area for 1 second. •• The Select Picture screen is displayed. 2. Select where the picture you want to edit is stored. •• The Crop screen is displayed. 3. Set the frame around the portion that will be cropped by dragging the anchors on the corners. 4. Touch "CROP" (ST-4001A) or "Done" ( ) (ST-4001I). Adding a text to the picture 1. Enter a text. 2. Touch . 3. Set the text font, size, color, and so on. LLSee page 3 (ST-4001A), or page 4 (ST-4001I) about each item. Saving the picture on the mobile device 1. Touch (ST-4001A) or (ST-4001I). •• The Select a Destination screen is displayed. 2. Select the destination to save the picture. LLIf you change the file name, enter one of up to 23 characters. LLYou can also send the picture to another application. (For only ST-4001I). 3. Touch "SAVE." (For only ST-4001A) Transferring the picture to the transceiver through a LAN 1. Touch the Menu icon. 2. Touch "Transfer Settings." 3. Touch "Using Network," and then touch "IP Address." 1Touch 2Touch 4. Enter the transceiver's IP address. LLSee the transceiver's manual about how to check its IP address. 5. Touch "OK." 6. Touch . 7. Operate the transceiver following to a displayed dialog. •• While transferring, (ST-4001A) or (ST-4001I) is displayed on the mobile device. LLTo cancel transfer, touch (ST-4001A) or "Cancel" (ST-4001I) on the mobile device. TIP: About IP address An IP address is a numerical label that is assigned to devices participating in a LAN. When the transceiver's DHCP setting is set to ON, the DHCP server assigns a dynamic IP address to your transceiver. Therefore, the mobile device has to match the IP address each time you transfer a picture to the transceiver. NOTE: If you cannot transfer the picture, check the following: On the transceiver •• The transceiver is turned ON. LLYou cannot transfer the picture if the transceiver is in the Standby mode. •• The transceiver and mobile device are connected to the same LAN. •• The transceiver's firmware is the latest version. •• An SD card or microSD card is inserted into the transceiver. •• The transceiver is in a normal operating mode. LLThe transceiver cannot receive the picture in special modes, such as the firmware update mode, clone mode, setting save mode, import or export mode, or touch screen calibration mode. •• Operate the transceiver following the displayed dialog. On the mobile device •• The transceiver's correct IP address is entered in Transfer Settings. - 5 -