Insignia NS-C5111 User Manual (English) - Page 15
Using your car deck - remote
View all Insignia NS-C5111 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
NS-C5111 Car Deck 3 Gently press the front panel into the notches. Caution Do not press the front panel too hard against your car deck, and do not press the LCD screen. You may damage the screen. 4 Swing the front panel up to close your car deck. Removing your car deck To remove your car deck: 1 Make sure that the car ignition is turned off, then disconnect the negative cable from the car battery. 2 Remove the metal strap from the back of your car desk (if attached). 3 Press the release button to open the front panel, then remove the front panel. 4 Lift the top of the outer trim ring, then pull it out. 5 Insert the release keys into the slots on the middle right and left sides of your car deck, then pull your car deck out of the dashboard. Using your car deck Turning your car deck on and off To turn your car deck on and off: 1 Press the PWR button on your car deck or the POWER button on your remote control to turn on your car deck. 2 Press and hold the PWR button on your car deck or the POWER button on your remote control for two seconds to turn off your car deck. Adjusting the volume To adjust the overall volume: • Turn the volume knob on your car deck left or right or press the VOL down or up button on your remote control to decrease or increase the volume. To adjust the initial volume: Note The initial volume is the volume level your car deck uses each time you turn on your car deck. 1 Press the function select button on your car deck or press the SEL button on your remote control for more than two seconds. 2 After you enter setup mode, press and release the function select or SEL button until IN VOL appears on the display. 14 www.insignia-products.com