Intel D525MW Product Specification - Page 47
Intel D525MW Manual
View all Intel D525MW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Technical Reference 2.2.2.4.1 Hard Drive Activity LED Header Pins 1 and 3 can be connected to an LED to provide a visual indicator that data is being read from or written to a hard drive. 2.2.2.4.2 Reset Switch Header Pins 5 and 7 can be connected to a momentary single pole, single throw (SPST) type switch that is normally open. When the switch is closed, the board resets and runs the POST. 2.2.2.4.3 Power/Sleep LED Header Pins 2 and 4 can be connected to a single- or dual-color LED. Table 25 shows the default states for a single-color LED. Table 25. States for a One-Color Power LED LED State Off Blinking Steady Green Description Power off/hibernate (S5/S4) Sleeping (S3) Running/Away (S0/S1) NOTE The LED states listed in Table 25 are default settings that can be modified through BIOS setup. Systems built with a dual-color front panel power LED can also use alternate color state options. 2.2.2.4.4 Power Switch Header Pins 6 and 8 can be connected to a front panel momentary-contact power switch. The switch must pull the SW_ON# pin to ground for at least 50 ms to signal the power supply circuitry to switch on or off. (The time requirement is due to internal debounce circuitry on the board.) At least two seconds must pass before the power supply circuitry will recognize another on/off signal. 47