Intel D915PLWD English Product Guide - Page 14

Intel Desktop Board D915PLWD Product Guide Main Memory NOTE To be fully compliant with all applicable Intel® SDRAM memory specifications, the board should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your memory modules do not support SPD, you will see a notification to this effect on the screen at power up. The BIOS will attempt to configure the memory controller for normal operation. The desktop board supports dual or single channel memory configurations. Desktop Board D915PLWD supports dual or single channel memory configurations defined in Table 3. Table 3. Desktop Board D915PLWD Memory Configurations Memory Speed DDR 400 Processor Intel® Pentium® 4 processor Intel Pentium 4 processor FSB frequency (MHz) 800 533 Intel® Celeron® D processor DDR 333 Pentium 4 processor 800 Pentium 4 processor 533 Intel Celeron D processor Memory Speed Outcome (MHz) 400 400 333 333 Desktop board D915PLWD supports: • Two 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory Module (DIMMs) connectors with gold-plated contacts • Unbuffered, non-registered single or double-sided DIMMs • Serial Presence Detect (SPD) memory only • Non-ECC RAM • 2.5 V memory • Memory configurations listed below: ⎯ Up to 1.0 GB utilizing 512 Mb technology ⎯ Up to 2.0 GB utilizing 1 Gb technology Related Links: Go to the following links or pages for more information about: • The latest list of tested memory, http://support.intel.com/support/motherboards/desktop/ • SDRAM specifications, http://www.intel.com/technology/memory/ • Installing memory, page 32 in Chapter 2 14