Intel S5500HCV Service Guide - Page 35

Clearing the CMOS - ram

Get Intel S5500HCV - Server Board Motherboard PDF manuals and user guides
UPC - 735858207508
View all Intel S5500HCV manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

System Utilities Clearing the CMOS If you cannot access the BIOS setup screens, you must use the CMOS Clear jumper to reset the configuration RAM. The CMOS Clear jumper is located on jumper block J1E6. Figure 11. CMOS Clear Jumper 1. Power down the server and unplug the AC power cord. 2. Open the server chassis. For instructions, see your server chassis documentation. 3. Move the jumper (J1E6) from the default operating position (covering pins 1 and 2) to the reset / clear position (covering pins 2 and 3). 4. Wait 5 - 10 seconds. 5. Move the jumper back to default position, covering pins 1 and 2. 6. Close the server chassis and reconnect the AC power cord. 7. Power up the server. The CMOS is now cleared and you can reset it by going into the BIOS setup. Intel® Server Board S5520HC and S5500HCV Service Guide 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
System Utilities
Intel
®
Server Board S5520HC and S5500HCV Service Guide
35
Clearing the CMOS
If you cannot access the BIOS setup screens, you must use the CMOS Clear jumper to reset the configuration RAM.
The CMOS Clear jumper is located on jumper block
J1E6
.
Figure 11. CMOS Clear Jumper
1.
Power down the server and unplug the AC power cord.
2.
Open the server chassis. For instructions, see your server chassis documentation.
3.
Move the jumper (J1E6) from the default operating position (
covering pins 1 and 2
) to the reset / clear
position (covering pins 2 and 3).
4.
Wait 5 - 10 seconds.
5.
Move the jumper back to default position, covering pins 1 and 2.
6.
Close the server chassis and reconnect the AC power cord.
7.
Power up the server.
The CMOS is now cleared and you can reset it by going into the BIOS setup.