Invacare L-3XB Owners Manual - Page 54

12 ACCESSORIES 12.3 Installing/Removing/Using the Walker Holder ƽ WARNING After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely. The installation of the walker holder onto the back of the scooter seat significantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.  For this procedure, refer to FIGURE 12.3. Installing/Removing the Walker Holder  Reverse this procedure to remove the walker holder. 1. If necessary, loosen but DO NOT remove the mounting knob. 2. Install the walker holder into the accessory tube. 3. Thread the mounting knob into the welded nut on the accessory tube. Securely tighten. Using the Walker Holder 1. Fold walker. Refer to walker instructions. Walker Holder Accessory Tube Hook Accessory Tube  Walker MUST be folded before using walker holder. 2. Hang folded walker on walker holder hooks. 3. Secure walker with hook and loop straps. Hook and Loop Strap Mounting Knob Installs in One of These Locations Insert Into Accessory Tube Lynx™L-3X Scooter FIGURE 12.3 Installing/Removing the Walker Holder 54 Part No. 1145807