Invacare RPL450-1 Owners Manual - Page 26

Mounting the Battery Charger

Get Invacare RPL450-1 PDF manuals and user guides View all Invacare RPL450-1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

6 OPERATION 6.2 Mounting the Battery Charger  Refer to your local regulations concerning proper mounting procedures. 1. Place the battery charger with mounting bracket on the wall at the desired position. 2. With a pencil, mark the middle hole position. 3. Measure down 6½ inches from the pencil mark and drill one mounting hole. 4. Install the bottom mounting screw until there is an approximate 1/8-inch gap between the screw head and the wall. 5. Install the battery charger with mounting bracket onto the bottom mounting screw. 6. Drill the remaining two mounting holes. 7. Install the two remaining mounting screws through the mounting bracket and into the wall. Tighten securely. 8. Plug the battery charger into the wall electrical outlet.  ON LED should illuminate. Mounting Bracket (STEP 6) Battery Charger with Mounting Bracket (STEP 5) Mounting Screws (STEP 7) BOTTOM Mounting Screw (STEP 4) Manual/Electric Portable Patient Lift 26 Part No. 1078987

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
6 OPERATION
Manual/Electric Portable Patient Lift
26
Part No. 1078987
6.2
Mounting the Battery Charger
1.
Place the battery charger with mounting bracket
on the wall at the desired position.
2.
With a pencil, mark the middle hole position.
3.
Measure down 6½ inches from the pencil mark and drill one mounting hole.
4.
Install the bottom mounting screw until there is an approximate 1/8-inch gap between the screw head and the wall.
5.
Install the battery charger with mounting bracket onto the bottom mounting screw.
6.
Drill the remaining two mounting holes.
7.
Install the two remaining mounting screws through the mounting bracket and into the wall. Tighten securely.
8.
Plug the battery charger into the wall electrical outlet.
Refer to your local regulations concerning proper mounting procedures.
ON LED should illuminate.
Mounting Bracket (STEP 6)
Mounting Screws
(STEP 7)
Battery Charger with
Mounting Bracket (STEP 5)
BOTTOM Mounting Screw (STEP 4)