Invacare RPL600-1 Owners Manual - Page 26
Mounting the Battery Charger
View all Invacare RPL600-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
6 OPERATION 6.2 Mounting the Battery Charger Refer to your local regulations concerning proper mounting procedures. 1. Place the battery charger with mounting bracket on the wall at the desired position. 2. With a pencil, mark the middle hole position. 3. Measure down 6½ inches from the pencil mark and drill one mounting hole. 4. Install the bottom mounting screw until there is an approximate 1/8-inch gap between the screw head and the wall. 5. Install the battery charger with mounting bracket onto the bottom mounting screw. 6. Drill the remaining two mounting holes. 7. Install the two remaining mounting screws through the mounting bracket and into the wall. Tighten securely. 8. Plug the battery charger into the wall electrical outlet. ON LED should illuminate. Mounting Bracket (STEP 6) Battery Charger with Mounting Bracket (STEP 5) Mounting Screws (STEP 7) BOTTOM Mounting Screw (STEP 4) Manual/Electric Portable Patient Lift 26 Part No. 1078987