Invacare TDXSC2-CG Owners Manual 2 - Page 65
Removing/Installing the Footboard
View all Invacare TDXSC2-CG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
5 WHEELCHAIR OPERATION Tilting the Seat Assembly Forward 1. Using one hand, firmly grasp the front edge of the seat assembly and lift until seat assembly is no longer supported by the prop rod. 2. Disengage the prop rod from the front seat post and secure into clip. 3. Using both hands, slowly tilt the seat assembly FORWARD into the DOWN/CLOSED position. ƽ WARNING Ensure the two mounting screws, washers and locknuts are securely tightened and the seat frame is locked in place before use - otherwise injury or damage may result. 4. Using the two mounting screws, washers and locknuts, secure the seat frame plate to the two front seat posts. 5.10 Removing/Installing the Footboard ƽ WARNING After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely otherwise injury or damage may result. Before performing any maintenance, adjustment or service, verify that ON/OFF switch on the joystick is in the OFF position. DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair, make sure that the flip-up footboard is in the upward position. LIMITED CLEARANCE BETWEEN FOOTBOARD AND CASTER - The user's feet MUST remain on the footboard while operating the wheelchair. If the user's feet are allowed to rest off the side of the footboard they may come in contact with the caster possibly resulting in injury. For this procedure, refer to FIGURE 17 on page 66. Part No 1149267 65 Invacare® TDX® SC, Invacare TDX Spree