JVC DT-E17L4G Operation manual for DT-E17L4/DT-E21L4G Monitor (32 pages) - Page 13

Menu Transition Diagram Main Menu Picture Function Size/Position Adjust Aspect Signal Setting Marker Audio Setting Sync Function No Operation Action Backlight Aperture Aperture Level CTI LTI Gamma Color Temperature sub menu reset Auto Aspect Manual Aspect SD4ɿ3 Size Area Marker Marker Aspect Safety Marker Safety Area Frame Center Marker Line Brightness R-Area Marker R-Marker Aspect R-Safety Marker R-Safety Area No Sync Action Delay Time Low Latency Set-Up Menu Function Setting Picture Sub Adjust White Balance Setting Remote Setting Information Control Lock Language IMD all reset Contrast Bright Chroma Phase NTSC Setup Component Level sub menu reset Serial Type Parallel Type Pin1 Pin2 Pin3 Pin4 Pin5 Pin6 Pin7 Pin8 Source ID Character Setting Status Display Time Code CRC Error Sub Hour Meter Model Version Hour Meter Auto Adjust H Size H Position V Size V Postion Dot CMock Clock Phase sub menu reset Component/RGB Select Sampling Mode Wide XGA SXGA/SXGA+ I/P Mode Color System sub menu reset Balance Audio1 Assign Audio2 Assign Embedded Audio Group Level Meter Setting Level Meter Display Horizontal Channel Arrange Vertical Position Horizontal Position Meter Type Color Reference Level Over Level Bar Brightness Transparent Peak Hold sub menu Position Sync Term Tally Setting Dimmer Illumination Component Phase Remote Active On Standby LCD Saver Color Temperature* R Drive G Drive B Drive R Cut Off G Cut Off B Cut Off sub menu reset Tally Type Tally Color Setting Execute Cancel Status Start After IMD Display IMD Protocol Address IMD Size Text Color Tally 1 Color Tally 2 Color Background Color reset 1st Start Work Time Contrast Backlight OSD Contrast Side Mask reset * : "Color Temperature" is only displayed, and cannot be set/changed. 13