JVC FS-G6 Instruction Manual - Page 12

English Continued Connecting MD Recorder XM-G6 Connecting Antennas You can also connect the MD recorder XM-G6 (not supplied), specifically designed for FS-G6. This unit will complete FS-G6 compact component system. When you connect and use this unit, refer to the Instructions supplied with it for details. Supplied FM antenna ANTENNA AX-UXG6 XT-UXG6 External wire (supplied with XM-G6) External wire (supplied with FS-G6) FROM CONNECTOR-C XM-G6 TO CONNECTOR-C Optical digital cable (supplied with XM-G6) • DO NOT install XM-G6 until you turn off the system and unplug the AC power code, otherwise installation should fail to damage the system. • DO NOT change the vertical stacking order of XMG6 as illustrated to avoid heat buildup. CFOMA7X5IAL LOAMOP 1 Attach the FM antenna to the FM 75 Ω COAXIAL terminal on the rear panel of XT-UXG6. 2 Extend the FM antenna. 3 Fasten it up in the position which gives you the best reception. About the supplied FM antenna The FM antenna supplied with this unit can only be used as temporary measure. If reception is poor, you can connect an outdoor FM antenna. To connect an outdoor FM antenna Before connecting it, disconnect the supplied FM antenna. Connecting Sub Woofer System When using JVC external sub woofer system, connect audio cable between AX-UXG6's SUB WOOFER OUT jack and the input of your sub woofer system. Outdoor FM antenna (not supplied) ANTENNA SUBWOOFER OUT AX-UXG6 AX-UXG6 CFOMA7X5IAL LOAMOP Audio cable (not supplied) Sub Woofer System (not supplied) 7 A 75Ω antenna with coaxial type connector (DIN 45325) should be used.