JVC FS-G6 Instruction Manual - Page 13
Connecting Speakers
View all JVC FS-G6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
English AM antenna Continued Connecting Speakers You can connect the speakers using the speaker cords. 1 2, 3 ANTENNA AM EXT FM 75 COAXIAL Vinyl-covered wire (not supplied) AM LOOP Speaker Cord Red Speaker Cord RIGHT LEFT SPEAKERS Black AM loop antenna (supplied) Right speaker Left speaker 1 Connect the AM loop antenna to the AM LOOP terminals as illustrated. 2 Turn the AM loop antenna until you have the best reception. To connect an external AM antenna When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.) For better reception of both FM and AM • Make sure the antenna conductors do not touch any other terminals and connecting cables. • Keep the antennas away from metallic parts of the units, connecting cables, and the AC power cord. 1 Open the speaker terminal. 2 Insert the end of the speaker cord to the terminal. Match the polarity of the speaker terminals: Red (+) to red (+) and black (-) to black (-). 3 Close the speaker terminal on the rear of the unit. When connecting speaker cords • Make sure to connect the cords correctly following the right series of above steps. During operation, wrong connection or a short circuit make the power turned off to protect the system. The clock loses the setting and is reset to "0:00". Also the MD recording may fail. • Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit. 8