JVC GZ-HM200BUS Guide Book - Page 10

Read This First! How to use the Touch Sensor After the menu is displayed on the LCD monitor: A VIDEO EDIT PLAYLIST REC DUBBING PLAYBACK PLAYBACK OTHER FILE EDIT CAN BE SET TO PREVENT COPY SET QUIT Q Slide your finger up and down on the sensor. R Select [SET]. (Touch OK.) CAUTION Touch the sensors with your finger. The sensors do not function if you touch them with your fingernail or with gloves on. B A To select an on-screen button appearing on the left side, touch the portion of the sensor next to the on-screen button. B To select an on-screen button appearing at the bottom of the screen, touch the buttons underneath them. Make a backup of important recorded data JVC will not be responsible for any lost data. It is recommended to copy your important recorded data to a disc or other recording media for storage. (Z p. 46) Make a trial recording Before the actual recording of important data, make a trial recording and play back the recorded data to check that the video and sound have been recorded correctly. We recommend you to use the same recording media when performing both the trial recording and the actual recording. Reset the camcorder if it does not operate correctly Close the LCD monitor and remove the power supply (battery pack or AC adapter) from the camcorder, then reattach it. Precautions on handling batteries • Be sure to use the JVC BN-VF808U/ VF815U/VF823U battery packs. This product includes patented and other proprietary technology and is made to be used with the JVC battery and not with other batteries. JVC cannot guarantee safety or performance of this product when it is operated by other batteries • If the camcorder is subjected to electrostatic discharge, turn off the power before using it again. 10 If a malfunction occurs, stop using the camcorder immediately and contact www.jvc.com or by phone at 1-800-252-5722 Recorded data may be erased while the camcorder is being repaired or inspected. Back up all data before requesting repairs or inspections. Because camcorders may be used for demonstration in a shop, the demonstration mode is set to [ON] by default To deactivate the demonstration mode, set [DEMO MODE] to [OFF]. (Z p. 64) When Using an SD Card • Operations are confirmed on the following SD cards: Class 4 or higher compatible SD or SDHC card. Panasonic, TOSHIBA, SanDisk, ATP SD card (256 MB to 2 GB) or SDHC card (4 GB to 32 GB) For UXP mode, use Class 6 or higher. • If other media are used, they may fail to record data correctly, or they may lose data that had already been recorded. • MultiMediaCards are not supported.