JVC GZ-HM400US Instructions - Page 18

GETTING STARTED Other Settings Using an SD Card The camcorder is programmed to record on the built-in memory when it is shipped from the factory. You can change the recording medium to an SD card. • Operations are confirmed on the following SD cards. - Panasonic - TOSHIBA - SanDisk - ATP Video recording: Class 4 or higher compatible SDHC card (4 GB to 32 GB) Still image recording: SD card (256 MB to 2 GB) or SDHC card (4 GB to 32 GB) • Operations are not guaranteed if any other SD card than the mentioned above is used. • If other media are used, they may fail to record data correctly, or they may lose data that had already been recorded. • MultiMediaCards are not supported. • Video data may not be recorded onto the SD cards on which video data have already been recorded using the devices from other manufacturers. • It is recommended to use Class 6 when recording video in UXP mode. NOTE No SD card is supplied with your camcorder. Insert an SD card Preparation: Press the < (Power) button for more than 2 seconds to turn off the camcorder. 1 Slide the OPEN knob to open the SD card cover. 2 Firmly insert the card with its clipped edge first. 3 Close the SD card cover.  To remove an SD card Push the SD card once. After the card comes out a little, pull it out. NOTE • Insert and remove the SD card only while the power is turned off. Otherwise, data on the card may be corrupted. • Do not touch the terminal on the reverse side of the label. Change the recording medium Set [MEDIA SETTINGS] & [REC MEDIA FOR VIDEO] and [REC MEDIA FOR IMAGE] to [SD CARD]. Format an SD card when using it for the first time Select [MEDIA SETTINGS] & [FORMAT SD CARD] to format the card. OPEN Knob 18 EN