JVC KD-R540 Instruction Manual - Page 10

AUDIO SETTINGS To Do this Select a preset equalizer Press EQ repeatedly. FLAT (default), NATURAL, DYNAMIC, VOCAL BOOST, BASS BOOST, USER Store your own sound settings 1 Press and hold EQ. 2 Turn the volume knob to make a selection, then press the knob. SUB.W *1: -08 to +08 Default: (00) BASS LVL: -06 to +06 (00) MID LVL: -06 to +06 (00) TRE LVL: -06 to +06 (00) • The setting is stored to [USER] in EQ. • To return to the previous item, press G. • To exit, press EQ. *1 Displayed only when [L/O MODE] is set to [SUB.W] and [SUB.W] is set to [ON]. Other settings 1 Press and hold MENU. 2 Turn the volume knob to select [PRO EQ] or [AUDIO], then press the knob. 3 Turn the volume knob to make a selection (see the table below), then press the knob. Repeat step 3 until the desired item is selected. 4 Press MENU to exit. PRO EQ 1 BASS / MIDDLE / TREBLE: Select a sound tone. 2 Adjust the sound elements of the selected sound tone. BASS Frequency: 60/ 80/ 100/ 200 Hz Level: -06 to +06 Q: Q1.0/ Q1.25/ Q1.5/ Q2.0 Default: (80 Hz) (00) (Q1.0) MIDDLE Frequency: Level: Q: 0.5/ 1.0/ 1.5/ 2.5 kHz -06 to +06 Q0.75/ Q1.0/ Q1.25 Default: (1.0 kHz) (00) (Q1.25) TREBLE Frequency: Level: Q: The setting is stored to [USER] in EQ. 10.0/ 12.5/ 15.0/ 17.5 kHz -06 to +06 Q FIX Default: (10.0 kHz) (00) (Q FIX) Default: XX AUDIO FADER*2 *3 BALANCE *3 R06 - F06 (00): Adjusts the front and rear speaker output balance. L06 - R06 (00): Adjusts the left and right speaker output balance. BASS BOOST LOUD +01 / +02: Selects your preferred bass boost level. ; OFF: Cancels. LOW / HIGH: Boosts low or high frequencies to produce a wellbalanced sound at low volume. ; OFF: Cancels. VOL ADJUST -05 - +05 (00): Presets the volume adjustment level of each source (compared to the FM volume level). Before adjustment, select the source you want to adjust. ("VOL ADJ FIX" appears if FM is selected.) L/O MODE SUB.W / REAR: Selects whether rear speakers or a subwoofer are connected to the REAR/SW line out terminals on the rear panel (through an external amplifier). SUB.W *4 SUB.W LPF*5 SUB.W LEVEL*5 BEEP TEL MUTING*6 ON / OFF: Turns on or off the subwoofer output. THROUGH: All signals are sent to the subwoofer. ; LOW 55Hz / MID 85Hz / HIGH 120Hz: Audio signals with frequencies lower than 55 Hz/ 85 Hz/ 120 Hz are sent to the subwoofer. -08 - +08 (00): Adjusts the subwoofer output level. ON / OFF: Activates or deactivates the keypress tone. ON: Mutes the sounds while using the cellular phone (not connected through KS-BTA100). ; OFF: Cancels. AMP GAIN LOW POWER: Limits the maximum volume level to 30. (Select if the maximum power of each speaker is less than 50 W to prevent damaging the speakers.) ; HIGH POWER: The maximum volume level is 50. *2 If you are using a two-speaker system, set the fader level to [00]. *3 This adjustment will not affect the subwoofer output. *4 Displayed only when [L/O MODE] is set to [SUB.W]. *5 Displayed only when [SUB.W] is set to [ON]. *6 Does not work if [BT ADAPTER] is selected for [AUX] in [SRC SELECT]. 10 EN_KD-A645_R640_540_440[J]f.indd 10 7/24/12 12:21:24 PM