JVC KD-R540 Instruction Manual - Page 14

INSTALLATION / CONNECTION Warning • The unit can only be used with a 12 V DC power supply, negative ground. • Disconnect the battery's negative terminal before wiring and mounting. • Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire (black) to prevent a short circuit. • Insulate unconnected wires with vinyl tape to prevent a short circuit. • Be sure to ground this unit to the car's chassis again after installation. Caution • For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer. • Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot. • Do not connect the · wires of speaker to the car chassis, Ground wire (black), or in parallel. • Connect speakers with a maximum power of more than 50 W. If the maximum power of the speakers is lower than 50 W, change the [AMP GAIN] setting to avoid damaging the speakers. (« 10) • Mount the unit with the angle of 30° or less. • If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red) to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned on and off by the ignition key. • After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly. • If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old fuse with one that has the same rating. Basic procedure 1 Remove the key from the ignition switch, then disconnect the · terminal of the car battery. 2 Connect the wires properly. See Wiring connection. (« 15) 3 Install the unit to your car. See Installing the unit (in-dash mounting). 4 Connect the · terminal of the car battery. 5 Reset the unit. (« 3) Installing the unit (in-dash mounting) Do the required wiring. (« 15) Bend the appropriate tabs to hold the sleeve firmly in place. Make sure the direction of the trim plate. When installing without the mounting sleeve Flat or round head screws (not supplied) M5 × 8 mm (M5 × 3/8") How to remove the unit Pocket Bracket (not supplied) 14 EN_KD-A645_R640_540_440[J]f.indd 14 7/24/12 12:21:25 PM