Kenmore 4412 Use and Care Guide - Page 7
¸i
View all Kenmore 4412 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
DOOR REMOVAL If door must be removed: • Unplug the unit • Gently lay refrigerator on its back, on a rug or blanket. • Remove two base screws and base panel. Remove wire from clips on bottom of cabinet, if required. • Unplug connector, if required, by holding the cabinet connector in place and pulling the door connector out. • Remove the bottom hinge screws. • Remove the plastic top hinge cover. • Remove the screws from the top hinge. • Remove the top hinge from the cabinet. • Remove the door and bottom hinge from the cabinet. • To replace door, reverse the above procedures and securely tighten all screws to prevent hinge slippage. Base Panel -- Base Panel Screws iNTERiOR LIGHTING The light comes on automatically when the door is opened. The light bulb assembly is located on the back of the refrigerator control box.To replace the light bulb, turn the temperature control to "OFF" and unplug the electrical cord. Replace the old bulb with a bulb of the same type and wattage. Hinge Screws Wire -- Door Connector Cabinet Connector SPILL PROOF SLIDE-OUT GLASS SHELVING Multi-position adjustable slide out glass shelves can be moved to any position for larger or smaller packages. The shipping spacers that stabilize the shelves for shipping may be removed and discarded. COOL DOWN PERIOD For safe food storage, allow four (4) hours for refrigerator to cool down completely.The refrigerator will run continuously for the first several hours. ELECTRONIC TEMPERATURE CONTROL The electronic temperature control is located inside the refrigerator. Temperature is factory preset to provide satisfactory food storage temperatures. However, the temperature control is adjustable to provide a range of temperatures for your personal satisfaction. To adjust the temperature setting, move the UP (/\) button for warmer temperature and DOWN (V) button for colder temperature on the control panel. Allow several hours for the temperature to stabilize between adjustments. TO ADJUSTTHE SHELVES iiii ¸i i • Lift front edge up. • Pull shelf out • Replace the shelf by inserting the hooks at rear of the shelf into the wall bracket. Lower the shelf into the desired slots and lock into position. FRIDGETEMP 7 is coNest 0 is off