Kenmore 7531 Use and Care Guide - Page 13

REVERSE REFRIGERATOR DOOR Before reversing the door, remove the Base Grille. See BASE GRILLE INSTALLATION for reference • Remove the cover on the left side of base grille and )lace it on the right side. Le_ cover Using an adjustable wrench remove Bottom Nut. As described in REMOVE REFRIGERATOR DOOR. Insert flat blade screwdriver into corner notches on bottom of dispenser cover. Pry base off cover loose. CAREFULLY pull cover forward to detach clips on sides and top of cover, and disconnect the wire connector on the back of the dispenser cover. Set cover aside. Right cover Fig. 27 Use phillips screwdriver to remove tube guide screw. Pull tube all the way up and out of door. Set tube aside. Fig. 28 Fig. 25 H li Locate the quick connector next to the Bottom Hinge and disassemble with the next steps: 1. Remove locking clipQ and set aside. 2. Press back collet and pull out water connection tube (::Z). 18 _tube guide screw left channel rtgn_ channel b-4 -_ Fig. 26 bottom hinge , Using a 1/4" socket wrench, loosen and remove hinge pin from the middle hinge pin bracket. Remove washer underneath the middle hinge and set aside. Fig. 29 _._- Collet Tube • Lift up the door watching carefully that wire harness doesn't get damaged by the Hinge Pin. Fig. 30 Insert lines Locking clip I • Carefully disconnect wire harness connectors next to Bottom Hinge. As described in REMOVE REFRIGERATOR DOOR. 13