Kenwood DDX7035 User Manual 1 - Page 47

unit. Displaying the Speaker Set Up screen When the speaker type and size are set, the speaker crossover network and equalizer curve are set automatically. Speaker Set Up screen Audio Set Up SRC Menu 7 X ' Ov e r HPF 8 X ' Ov e r LPF 10M u l t i C h a n n e l 10 3/2 9 F r o n t L&R 9 Standard 11 S u b Woo f e r Off 13 Sp e a k e r 12 Displaying the Channel Level screen You can set the volume at each setup position. Channel Level screen 14 Menu Audio Set Up 16 Te s t SRC 15 Ce n t e r 15 + 1 0 dB 17 Chann e l Level 7 Displays the X'over (HPF) screen. (See , page 50) 8 Display the X'over (LPF) screen. (See , page 50) 9 Sets up the front speaker type to fine-tune for the optimal equalizer curves. Standard: Setup for general diameter speakers Narrow: Setup for small diameter speakers Middle: Setup for small diameter woofer Wide: Setup for large diameter woofer p Select the speakers for Multi-channel sounds. "3/2": Center speaker, Front speaker, Rear speaker "2/2": Front speaker, Rear speaker "3/0": Center speaker, Front speaker "2/0": Front speaker q Set the use or no use of Sub Woofer. w Displays the Channel Level Setup screen. e Displays the Car Type Set Up screen. • "X'Over HPF" and "X'Over LPF" can be set only when "Sub Woofer" is set to "On". • "Multi Channel" can be set only when "Dolby Pro Logic" (see page 75) is set to "On". r Selects a speaker to be set. (see , page 48) t Sets the speaker volume. (see , page 48) y Starts or stops test signal tone output for setup check. u Displays the Speaker Set Up screen. • Your setup on the is adjusted automatically to get the best sound effects according to the car type and speaker you have set on the (see page 46). We recommend you to complete the first, then set up the . You can fine-adjust the automatic set value by (see page 48) or (see page 72). • Stop the test signal tone if you have finished setting up the Channel Level. If you leave the test signal tone on, you may not be able to set up other settings. English 47