Kenwood DNR8025BT Quick Start Guide - Page 25
Attaching the front panel, DNN9250DAB/ DNR8025BT, Trim plate, First Step P.7
View all Kenwood DNR8025BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
ÑÑUnit 1) To prevent a short circuit, remove the key from the ignition and disconnect the ¤ terminal of the battery. 2) Make the proper input and output wire connections for each unit. 3) Connect the wire on the wiring harness. 4) Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle. 5) Take Connector A on the wiring harness and connect it to the external power connector on your vehicle. 6) Connect the wiring harness connector to the unit. 7) Install the unit in your car. 8) Reconnect the ¤ terminal of the battery. 9) Press the button. (P.4) 10)Perform the Initial Setup. See First Step (P.7). ÑÑAttaching the front panel (DNN9250DAB/ DNR8025BT) Hold the front panel securely so as not to drop it accidentally. Fit the panel onto the attaching plate until it is firmly locked. 4 1 1 2 Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. ✎✎NOTE • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). 3 ÑÑTrim plate 1) Attach accessory 5 to the unit. 5 English ñ 25