Kenwood DNR8025BT Quick Start Guide - Page 29
Color and functions, Connecting wires to terminals
View all Kenwood DNR8025BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
ÑÑConnecting wires to terminals DNN9250DAB/ DNR8025BT Fuse (10A) HDMI/MHL MIC AV-IN/OUT M4 x 8mmMAX iPod/ AV-IN2 REMOTE OUT DNN6250DAB Fuse (10A) HDMI/MHL MIC R-CAM GPS M4 x 8mmMAX iPod/ AV-IN2 REMOTE OUT AV-OUT FUSE 10A SW FRONT REAR DAB FUSE 10A SW FRONT REAR AV-OUT AUDIO EXT I/F R L POWER AV-OUT AUDIO EXT I/F R L POWER Accessory 1 ab Connector A 8642 7531 8642 7531 Connector B Pin Color and functions A4 Yellow A5 Blue/White A6 Orange/White A7 Red A8 Black B1/B2 Purple ¢ / Purple/Black ¤ B3/B4 Gray ¢ / Gray/Black ¤ B5/B6 White ¢ / White/Black ¤ B7/B8 Green ¢ / Green/Black ¤ *Speaker Impedance: 4-8 Ω Battery Power Control Dimmer Ignition (ACC) Earth (Ground) Connection Rear Right Front Right Front Left Rear Left P.CONT ANT.CONT Blue/White (Power control/ Antenna control wire) Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle. MUTE 2 WARNING for Connecting the ISO Conncetor The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent damage to the unit. The default connection for the wiring harness is described in (1) below. If the ISO connector pins are set as described in (2), make the connection as illustrated. Please be sure to reconnect the cable as shown (2) below to install this unit to the Volkswagen vehicles etc. Brown (Mute control wire) Connect to the terminal that is grounded when either the telephone rings or during conversation. To use the Mute feature, you need to hook up this wire to your telephone by using a commercial telephone accessory. STEERING WHEEL REMOTE CONT REMOTE INPUT Light Blue/Yellow (Steering remote control wire) To steering remote To use the steering wheel remote control feature, you need an exclusive remote adapter (not supplied) matched to your car. If no connections are made, do not let the cable come out from the tab. (1): Default setting The red (A-7 pin) of the vehicle's ISO connector is linked with the ignition, and the yellow (A-4 pin) is connected to the constant power supply. a Red (Ignition cable) Red (A-7 pin) Unit Vehicle b Yellow (Battery cable) Yellow (A-4 pin) (2) The red (A-7 pin) of the vehicle's ISO connector is connected to the constant power supply, and the yellow (A-4 pin) is linked to the ignition. a Red (Ignition cable) Unit b Yellow (Battery cable) Red (A-7 pin) Vehicle Yellow (A-4 pin) English ñ 29