Kenwood DNX7100 Installation Manual - Page 4
Connection - remote control
UPC - 019048170972
View all Kenwood DNX7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Connection Ignition key switch If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. ACC A B A Ignition wire (Red) Car fuse box (Main fuse) Car fuse box Battery wire (Yellow) B Ground wire (Black) - C (To car chassis) C -+ Battery FUSE ( 5A ) Antenna Cord Connect to the vehicle's parking brake detection switch harness using the supplied relay connector. Parking sensor wire (Light Green) PRK SW For the sake of safety, be sure to connect the parking sensor. To vehicle's reverse lamp harness Reveres sensor wire (Purple/White) To car light control switch To steering remote Dimmer control wire (Orange/White) Steering remote control input (Light Blue/Yellow) Connect to the terminal that is grounded when either Mute wire (Brown) the telephone rings or during conversation. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. When using the optional power amplifier, connect to its power control terminal. To "EXT.AMP.CONT." terminal of the amplifier having the external amp control function. Motor antenna control wire (Blue) Power control wire (Blue/White) External amplifier control wire (Pink/Black) If no connections are made, do not let the cable come out from the tab. 4 | DNX7100