Kenwood DVT-6200 User Manual - Page 58

DVD player unit, Remote control unit, Inhibition icon

Page 58 highlights

58 In case of difficulty DVD player unit DVT-6200 (EN/K,E,X) Symptom Cause Remedy Playback will not start even after a title is se- ÷ A viewing restriction (PARENTAL) has been ÷ Check the viewing restriction level (PA- lected. set for the disc. RENTAL) setting. The parental level cannot be changed. ÷ You have forgotten the password. ÷ Set the initial setup to the factory setup with the following procedure. 1 Press the MENU key on the remote to enter SETUP MENU. 2 Select the PREFERENCE, then press the ENTER key. 3 Select DEFAULTS, press the Cursor right (3) key to select RESET. 4 Press the numeric keys as shown below. Press 1, 3, 9, 7, then press the ENTER key. The password set at the time of shipping from the factory is "0000". The voice or subtitle language selected in the initial setting is not played. ÷ The DVD disc being played does not contain the recording of the selected voice or subtitle language. ÷ The initial playback language is specified by the DVD disc. ÷ The DVD specifications provide for selection at the menu screen. ÷ Use a DVD disc containing the recording of the selected voice or subtitle language. ÷ Press SUBTITLE or the AUDIO key on the remote and select the language. e ÷ Select at the menu screen of the disc. Menu screen messages are not shown in the ÷ The menu language function (MENU) is not ÷ Select disc menu language. desired language. set to desired language. ∞ A VCD cannot be played using menus. ÷ The VCD disc being played is not compatible ÷ Menu playback is available only with VCD with P.B.C. discs recorded with P.B.C. "THE PLAYER IS LOCKED" will be displayed on the TV screen (the mark on the display of the main unit will be lit), and disk tray opening/closing operation will not be accepted. ÷ Operation is prohibited. ÷ Press the MENU key of the remote control for several seconds while holding the stop (7) key on the main unit pressed. "THE PLAYER IS UNLOCKED" will be displayed (the mark will not be lit, and operation will become possible. Remote control unit Symptom Remote control operation is not possible. Cause ÷ Batteries are exhausted. ÷ The remote control is too far away from the system, the controlling angle is deviated or there is an obstacle in between. Remedy ÷ Replace with new batteries. ÷ Operate the unit inside the remote control- lable range. Inhibition icon Symptom Cause Remedy The inhibition icon is displayed and remote control is not possible. ÷ Playback is restricted intentionally by the software producer. ÷ The operation is inhibited. Please try another operation. Knowledge Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby Laboratories.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60

58
Knowledge
DVT-6200 (EN/K,E,X)
÷
A viewing restriction (
PARENTAL)
has been
set for the disc.
÷
You have forgotten the password.
÷
The DVD disc being played does not contain
the recording of the selected voice or subtitle
language.
÷
The initial playback language is specified by
the DVD disc.
÷
The DVD specifications provide for selection
at the menu screen.
÷
The menu language function (MENU) is not
set to desired language.
÷
The VCD disc being played is not compatible
with
P.B.C.
÷
Operation is prohibited.
÷
The operation is inhibited. Please try an-
other operation.
The inhibition icon is displayed
and remote control is not pos-
sible.
÷
Playback is restricted intentionally by the
software producer.
DVD player unit
÷
Check the viewing restriction level (
PA-
RENTAL
) setting.
÷
Set the initial setup to the factory setup
with the following procedure.
1
Press the
MENU
key on the remote to
enter
SETUP MENU
.
2
Select the
PREFERENCE
, then press
the
ENTER
key.
3
Select
DEFAULTS
, press the Cursor
right (
3
) key to select
RESET
.
4
Press the numeric keys as shown below.
Press
1
,
3
,
9
,
7
, then press
the
ENTER
key.
The password set at the time of shipping
from the factory is "0000".
÷
Use a DVD disc containing the recording of
the selected voice or subtitle language.
÷
Press
SUBTITLE
or the
AUDIO
key on the
remote and select the language.
÷
Select at the menu screen of the disc.
÷
Select disc menu language.
÷
Menu playback is available only with VCD
discs recorded with
P.B.C.
÷
Press the MENU key of the remote control
for several seconds while holding the stop
(
7
) key on the main unit pressed.
"THE PLAYER IS UNLOCKED" will be dis-
played (the
mark will not be lit, and op-
eration will become possible.
Playback will not start even after a title is se-
lected.
The parental
level cannot be changed.
The voice or subtitle language selected in the
initial setting is not played.
Menu screen messages are not shown in the
desired language.
A VCD cannot be played using menus.
"THE PLAYER IS LOCKED" will be displayed
on the TV screen (the
mark on the display
of the main unit will be lit), and disk tray open-
ing/closing operation will not be accepted.
Remote control unit
Remote control operation is not possible.
÷
Batteries are exhausted.
÷
The remote control is too far away from the
system, the controlling angle is deviated or
there is an obstacle in between.
÷
Replace with new batteries.
÷
Operate the unit inside the remote control-
lable range.
Inhibition icon
Manufactured under license
from Dolby Laboratories.
"Dolby" and the double-D symbol are trademarks of Dolby
Laboratories.
Remedy
Cause
Symptom
Remedy
Cause
Symptom
Remedy
Cause
Symptom
In case of difficulty
e