Kenwood K-8302 Operation Manual - Page 6
Installing the Transceiver
View all Kenwood K-8302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
■ Installing the Transceiver For passenger safety, install the transceiver securely using the supplied mounting bracket and screw set, so the transceiver will not break loose in the event of a collision. Note: Before installing the transceiver, check how far the mounting screws will extend below the surface. When drilling mounting holes, be careful not to damage vehicle wiring or parts. 1 Mark the position of the holes in the dash, using the mounting bracket as a template. Using a 4.2 mm (5/32 inch) drill bit, drill the holes, then attach the mounting bracket using the supplied screws. • Mount the transceiver within easy reach of the user and where there is sufficient space at the rear of the transceiver for cable connections. 2 Connect the antenna and the supplied power cable to the transceiver. 3 Slide the transceiver into the mounting bracket and secure it using the supplied hex-headed screws. 4 Mount an optional microphone hanger in a location where it will be within easy reach of the user. • The microphone and microphone cable should be mounted in a place where they will not interfere with the safe operation of the vehicle. When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same value. Never replace a fuse with one that is rated with a higher value. Flat washer M4 x 6 mm Hex-headed screw Spring washer 5 x 16 mm Self-tapping screw Optional microphone Antenna connector Power input connector Black (-) cable Red (+) cable DC power cable 2 Mounting bracket Fuse 12 V vehicle battery