Kenwood KCA-SR50 Instruction Manual - Page 10

Troubleshooting Guide If you use this for the first time, it may be difficult to receive signals in the beginning. In such a case, leave the SIRIUS source ON for 3 minutes and turn it OFF and ON. What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. fJ The SIRIUS mode cannot be selected. ..... The SIRIUS connection wire is not connected. ~ Use the SIRIUS connection wire to connect the control unit and the SIRIUS satellite radio tuner. -ti'--Th-e-ch-a-rige;-svitc}iing'urii-t-'~K-C-A~S220A"is not connected properly. ~ Connect the KCA-SRSO to the terminal labelled TO CHANGER 2. See the section on . fJ Nothing happens when the buttons are pressed. ..... The computer chip in the unit is not functioning normally. ~ Press the reset button on the Control unit. fJ No broadcast can be received . ..... No subscription is established. ~ Subscribe to SIRIUS. The following messages are displayed when certain problems are occurring in your system. Take the recommended actions. ANTENNA ERROR I ANT ERR I ANT ERROR: Antenna is not connected correctly. ¢ Make sure the antenna is connected correctly and then turn OFF ION of the SIRIUS source or Control unit. TUNER ERROR ITUNE ERR: Broadcast cannot be received due to an error in this unit. ¢ Turn OFF ION of the SIRIUS source or Control unit, or press the reset button of Control unit. ESN ERROR I ESN ERR: ESN (Electronic Serial Number) is not registered in this unit. ¢ Consult your nearest service center. CHECK SIRIUS I CHK SSR : The SIRIUS tuner is disconnected or a unit other than the SIRIUS tuner is connected . ¢ Check the connection to the SIRIUS tuner. 10 I English