Kenwood KCA-SR50 Instruction Manual - Page 6

Operations Channel Scan Every receivable channel is checked for 10 seconds. 1 Start Channel Scan Press the [AUTO] button for at least 2 seconds. The channel scan will start. 2 Release it when the channel you want to listen to is received Press the [AUTO] button for at least 2 seconds. Switching Seek Mode Sets the seeking mode. Press the [AUTO] button. Each time the button is pressed, the Seek mode switches as shown below. OIsplly .... "Channel"I"CHANNEL" "Preset" I" PRESET" Normal manual seeking control. Search in order of the channels in the Preset memory b\. ~ • This function cannot be used in the category and channel search mode Category and Channel Search Select the category and channel you wish to listen to. 1 Enter category and channel search mode Press the [~II] button. 2 Select the category II Push the Control knob towards up or down. II Press the [FM] or [AM] button. 3 Select the channel II Push the Control knob towards right or left. II Press the [~] or [~] button. Canceling category and channel search mode Press the [~II] button. @2 You cannot operate this unit until all the Category information is acqUired. Switching Display When you are listening to the Sirius satellite radio, you can switch over the display information as follows. For operations, see the page of the instruction manual of your control unit. ~ ~ • What is displayed may partly depend on control units to be connected. Information., ': Channel Name Song Title Artist Name Composer name Category Name Band & Channel Number b\. ~ If the text, including Channel name, etc. is selected when the channel which does not have text, including Channel name, etc. is played, band & channel number is displayed. Function ofremote control Direct Access Tuning Entering the channel and tuning. 1 Enter Direct Access Tuning mode Press the [DIRECT] button on the remote control. 2 Enter the channel Press the number buttons. 3 Do Channel Search Press the [~] or [~] button. Cllnceling Direct Access Tuning Press the [DIRECT] button on the remote control. ~ ~ If you make no button operation for 10 seconds, the Direct Access Tuning mode is automatically canceled If you cannot receive any signal in the input channel due to a bad condition on radio wave or another problem, "Acquiring Signal"! "ACQUIRING SIGNAL" appears. 6 I English