Kenwood KCA-SR50 Instruction Manual - Page 7

Accessories, Installation Procedure - sirius antenna

Get Kenwood KCA-SR50 - Complete Sirius Satellite Radio System PDF manuals and user guides
UPC - 093207026133
View all Kenwood KCA-SR50 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Accessories/ Installation Procedure Accessories L_-------l' L 2 L_~..41 Installation Procedure 1. To prevent a short circuit, remove the key from the ignition and disconnect the 8 battery. 2. Connect the SIRIUS interface box and the control unit using the provided SIRIUS connection wire. 3. Make the proper input and output wire connections for each unit. 4. Install the unit in your car. 5. Reconnect the 8 battery. 6. Press the reset button. ~ Do not connect the SIRIUS connection wire while the control unit is turned ON. Be sure to press the reset button on the control unit after installation. If your car is not prepared for this special connectionsystem, consult your Kenwood dealer. Make sure that all wire connections are securely made by inserting jacks until they lock completely. Do not let unconnected wires or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits, also do not remove the caps on the ends of the unconnected wires or the terminals. Insulate unconnected wires with vinyl tape or other similar material. Take care so that the antenna wire and other connection wires are not caught by mobile parts. Otherwise wire disconnecticn or other trouble may result. Do not apply too much force on the antenna wire, other connection wires and connectors by bending a wire, etc. Otherwise wire disconnection or other trouble may result. After the unit is installed, check whether the brake lamps, indicators, wipers, etc. on the car are working properly. English I 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
Accessories/
Installation Procedure
Accessories
Installation
Procedure
1.
To
prevent a short circuit, remove the
key
from the
ignition and disconnect the
8
battery.
2.
Connect the
SIRIUS
interface box and the control
unit
using the provided
SIRIUS
connection wire.
3.
Make the proper
input
and
output
wire
connections for each unit.
4.
Install the
unit
in your
car.
5.
Reconnect the
8
battery.
6.
Press
the
reset
button.
~
Do not connect the
SIRIUS
connection wire while the
control
unit
is
turned
ON.
Be
sure
to
press
the reset
button
on the control
unit
after
installation.
If your
car
is
not
prepared for this special connection-
system, consult your Kenwood dealer.
Make sure that
all
wire connections
are
securely made
by
inserting jacks until they lock completely.
Do
not
let unconnected wires or terminals touch metal on
the car or anything else conducting electricity.
To
prevent
short circuits, also
do
not
remove the caps on the ends
of
the unconnected wires or the terminals.
Insulate unconnected wires with vinyl tape or other similar
material.
Take
care
so
that the antenna wire and other connection
wires
are
not
caught by mobile parts. Otherwise wire
disconnecticn or other trouble may result.
Do
not
apply
too
much force on the antenna wire, other
connection wires and connectors by bending a wire, etc.
Otherwise wire disconnection or other trouble may result.
After the
unit
is
installed, check whether the brake lamps,
indicators, wipers, etc. on the
car
are
working properly.
L_-------'
l
L
2
L_~
..41
English
I
7