Kenwood KDC-148 Instruction Manual - Page 3

ENGLISH Preparation How to attach/detach the faceplate 1 1 2 2 How to prepare the remote controller (RC-405) When you use the remote controller for the first time, pull out the insulation sheet. Insulation sheet Do not expose the faceplate to direct sunlight, excessive heat, or humidity. Also avoid places with too much dust or the possibility of water splashing. Keep the faceplate in its casing while detached. The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. To prevent deterioration, do not touch the terminals of the unit and faceplate with your fingers. How to reset your unit If this unit fails to operate properly, press the reset button. Reset button The unit returns to factory settings when the reset button is pressed. Discs that cannot be used Discs that are not round. Discs with coloring on the recording surface or discs that are dirty. You cannot play a Recordable/ReWritable disc that has not been finalized. (For the finalization process refer to your disc writing software, and your disc recorder instruction manual.) 3-inch CD cannot be used. Attempt to insert using an adapter can cause malfunction. If the effectiveness of the remote controller decreases, replace the battery. 3 2 4 1 CALIFORNIA, USA ONLY This perchlorate WARNING applies only to the product sold or distributed in California USA "Perchlorate Material-special handling may apply, See www.dtsc.ca.gov/ hazardouswaste/perchlorate." Caution: Do not set the remote control in hot places such as on the dashboard. Lithium battery. Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type. The battery pack or batteries shall not be exposed to excessive heat such sunshine, fire or the like. Keep battery out of reach of children and in original package until ready to use. Dispose of used batteries promptly. If swallowed contact physician immediately. Remote controller (RC-405) is equipped for KDC-148/ KDC-MP148CR. 3