Kenwood TS-870S User Manual - Page 16

3 GETTING ACQUAINTED FRONT PANEL qw e r ty u i o ANT ATT DOWN UP VOX FULL/SEMI AIP AT TUNE THRU/AUTO SEND AGC METER HF TRANSCEIVER PROC MONI KEY SPEED PROC 4 MONI 6 TS-870 1 CH 1 6 M.IN ON AIR 2 CH 2 7 M>VFO ENTER PHONES MIC SLOW OFF CAR 4 2 0 2 FAST 0 DELAY MIC 6 4 8 2 10 0 8 3 CH 3 8 SCAN 10 PWR 6 8 10 4 CH 4 9 CLR 5 REC 0 F.LOCK QUICK MEMO M.IN MR FINE !0 !1 !2 !3 q (POWER) switch Press and hold down briefly to switch the transceiver power ON. Press again to switch OFF the power {page 19}. w ATT DOWN/UP buttons Press either button to step up or down through the available receive signal attenuator selections. The attenuator is OFF when all three selections of 6, 12, and 18 dB are not lit {page 53}. e ANT button Press to select Antenna 1 or Antenna 2 that are connected to their respective antenna connectors on the Rear Panel {pages 2, 63}. r VOX button In the voice modes, press to switch the Voice-Operated Transmit function ON or OFF {page 45}. In CW mode, switches the Break-in function ON or OFF {page 31}. t FULL/SEMI button In CW mode, press to select Full or Semi Break-in operation which affects the transmit/receive recovery time after sending stops {page 31}. y AIP button Press to switch the Advanced Intercept Point function ON or OFF. When activated, the AIP function reduces interference caused by the presence of very strong signals. The function lowers the receive sensitivity by about 10 dB, and the default is ON when frequencies below 7490 kHz are selected {page 53}. DIGITAL SIGNAL PROCESSOR AUTO NOTCH BEAT CANCEL N.R. TX EQ. LO/WIDTH FILTER HI/SHIFT AT TUNE TF-SET 1MHz MODE LSB /USB CW/- R FSK /- R FM/AM DOWN A=B MENU RX TX A B M.CH UP RIT XIT CLEAR NB RIT/XIT AF 4 2 RF 6 8 M.CH/VFO.CH 0 NB 4 2 10 SQL 6 8 0 10 u AT TUNE button After enabling the internal antenna tuner via the THRU/AUTO button, press to activate the tuner. The tuner will attempt to match the transceiver with the antenna system {page 49}. i SEND button Press to switch the transceiver between receive and transmit {page 23}. o PHONES jack Connect headphones to this jack. Inserting a plug into this jack automatically mutes the audio from the speaker {page 4}. !0 THRU/AUTO button Press to enable the internal antenna tuner. This button does not start the tuning action (see u). The tuner can be configured so that it is only in-line while transmitting, or it can be in-line while both transmitting and receiving {page 49}. !1 METER button Press to switch between the available functions on the Front Panel meter {page 22}. !2 PROC button In SSB or AM mode, press to switch the Speech Processor ON or OFF {pages 23, 46}. !3 MONI button Press to switch the Transmit Monitor function ON or OFF so you can monitor your transmitted signal {page 46}. 10