Kenwood VR-616 User Manual - Page 10

Setting up the system Digital connections The digital in jacks can accept DTS, Dolby Digital, or PCM signals. Connect components capable of outputting DTS, Dolby Digital, or standard PCM (CD) format digital signals. If you have connected any digital components to the receiver, be sure to read the "Input mode settings" section carefully. 7 GND SYSTEM CONTROL VIDEO DVD IN VIDEO 2 IN FM 75Ω AM ANTENNA MONITOR OUT L AUDIO R VIDEO 1 IN VIDEO 1 OUT PHONO CD / DVD REC OUT PLAY IN REC OUT PLAY IN PLAY IN MD / TAPE VIDEO1 VIDEO 2 S VIDEO DVD CD / DVD OPTICAL VIDEO 2 COAXIAL DIGITAL IN DVD / 6CH INPUT CENTER MONITOR DVD VIDEO 2 OUT IN IN FRONT SPEAKERS (8-16Ω) CENTER SPEAKER (8-16Ω) + SURROUND SPEAKERS (8-16Ω) + FRONT SURROUND SUB WOOFER R SUB WOOFER RED PRE OUT - L WHITE C R GREEN GRAY SPEAKERS - L BLUE AC OUTLETS AC110V-120V / 220V-240V~ AC 220240V~ AC 110120V~ 50 / 60Hz SWITCHED TOTAL 90W MAX. VOLTAGE SELECTOR DVD / 6CH CD / DVD OPTICAL VIDEO 2 COAXIAL DIGITAL IN COAXIAL DIGITAL OUT (AUDIO) RF digital demodulator (DEM-9991D) (sold separately) COAXIAL DIGITAL OUT (AUDIO) Component with DTS, Dolby Digital, or PCM COAXIAL DIGITAL OUT Connect the video signal and analog audio signals to the VIDEO 2 jacks. (See "Connecting video components".) 9 DOLBY DIGITAL RF OUT (AUDIO) PCM OUT LD player Optical fiber cable OPTICAL DIGITAL OUT (AUDIO) CD or DVD player To connect an LD player with a DIGITAL RF OUT, connect the LD player to the KENWOOD RF digital demodulator (DEM-9991D). Next, connect the DIGITAL OUT jacks of the demodulator to the DIGITAL IN jacks of the receiver. Connect the video signal and analog audio signals to the VIDEO 2 jacks. (See "Connecting video components".) 10 EN