Kenwood XD-701 User Manual - Page 33

Copying tape (Tape dubbing) The contents of the tape in deck A can be copied onto the tape in deck B. 1 Select the "TAPE" input. INPUT 33 Let's record XD-SERIES (En) Load tapes in the decks. Playing tape A A Recording tape 2 Select "[" (double-side recording) or """ (one-side recording). REV.MODE Preparation section Basic section Application section 3 Press the DUBBING key. DUBBING 4 Select "TAPE DUBBING" and press the SET key. 1. Select. 2. Press SET. MULTI CONTROL SET 5 Use the same tape transport directions. (1) Select the transport direction of deck A. 1. Select. 2. Press SET. MULTI CONTROL SET (2) Select the transport direction of deck B. MULTI CONTROL CD RECORD CD EDIT CD PGM RECORD TAPE DUBBING TAPE DUB BI | Scrolled display (TAPE DUBBING) ÷ When recording is started, the tape will be transported in the direction selected in this step. A DIR FWD A DIR RVS Check the tape transport direction indicators. A DIR FW D B DIR FWD B DIR RVS RETURN ÷ By selecting "RETURN" and pressing the ENTER key, the operation returns to the previous step so the current step can be restarted. ÷ Dubbing ends automatically when the side(s) to be dubbed has been completed. To stop dubbing REC/ARM 6 Start dubbing. ENTER ÷ The deck B will stop after creating a non-recorded portion of about 4 sec, and then the deck A will stop. ÷ Dubbing can also be stopped by pressing the stop (7) key. Note that the non-recorded space is not created in this case. The DOLBY NR key is not active in dubbing mode. The tape recorded on deck B assumes the same Dolby NR condition as the tape played on Note deck A. Knowledge sections