KitchenAid KBFN506EBS Installation Instructions - Page 22
Door Swing Adjustment
View all KitchenAid KBFN506EBS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Door Swing Adjustment 36" (91.4 cm) Single-Door Models 1. Check that the refrigerator door can open freely. If the door opens too wide, remove the door stop screw from the bottom hinge with a Torx† T15 screwdriver. 4. The door stop is located on the top hinge. A B C A A. Door stop screw 2. Hold the door open to a position that is less than 90°. 3. Replace the door stop screw in the bottom hinge and tighten. IMPORTANT: Do not place the door stop screw in the 130° position on Overlay Series models. See "Handle and Door Clearances." A. Door stop screw "A" B. Door stop screw "B" C. Door stop 5. Remove the two door stop screws. ■■ To remove the outer screw ("A"): With the door closed, firmly press the L-shaped bracket toward the center of the refrigerator until the screw is exposed. ■■ To remove the inner screw ("B"): Open the door 90° and the L-shaped bracket will expose the screw. AB C A. 130° C. 90° B. 110° (Overlay series)screw 42" (106.7 cm) Models 1. Check that the refrigerator door can open freely. If the door opens too wide, you will have to adjust the door stop position. 2. Grasp both ends of the top grille. 3. Push the top grille straight up, then pull straight out. Lay the grille on a soft surface. B A B A. Top grille B. Cabinet side trims A B A. Door stop screw "A" B. Door stop screw "B" 6. Reverse or rotate the door stop to the desired position as shown below. NOTE: For Overlay Series models, rout the hinge side of the custom door panels to a radius that is equal to at least half the thickness of the panel if a 130° door swing is desired. 130° 110° 22