KitchenAid KBLS19KCMS Use & Care Guide - Page 8

NOTE: Having someone push against the top of the wine cellar takes some weight off the leveling legs. This makes it easier to adjust the leveling legs. 4. Open the door and check to make sure that it closes as easily as you like. If not, tilt the wine cellar slightly more to the rear by turning both front leveling screws to the right. It may take several more turns, and you should turn both leveling legs the same amount. Base Grille Remove the Base Grille 1. Open the wine cellar door. 2. Using a Phillips screwdriver, remove the two screws. Push both tabs in toward the center to release the base grille from the wine cellar. A B A A. Tabs B. Screws 3. Remove the base grille. Replace the Base Grille 1. Open the wine cellar door. 2. Position the base grille so that both tabs align and the base grille snaps into place. Replace the two screws. Tighten the screws. WINE CELLAR USE Normal Sounds Your new wine cellar may make sounds that your old one didn't make. Because the sounds are new to you, you might be concerned about them. Most of the new sounds are normal. Hard surfaces, such as the flooring and surrounding structures, can make the sounds seem louder. The following describes the kinds of sounds and what may be making them. ■ Your wine cellar is designed to run more efficiently to keep your wine at the desired temperatures and to minimize energy usage. The high efficiency compressor and fans may cause your wine cellar to run longer than your old one. You may also hear a pulsating or high-pitched sound from the compressor or fans adjusting to optimize performance. ■ Rattling noises may come from the flow of refrigerant or items stored inside the wine cellar. 8 ■ As each cycle ends, you may hear a gurgling sound due to the refrigerant flowing in your wine cellar. ■ You may hear water running into the drain pan when the wine cellar is defrosting. ■ You may hear clicking sounds when the wine cellar starts or stops running. Using the Control For your convenience, your wine cellar control is preset at the factory. When you first install your wine cellar, make sure that the control is still preset to the mid-setting as shown. Adjusting Controls The mid-setting indicated in the previous section should be correct for normal usage. The control is set correctly when beverages are as cold as you like. If you need to adjust the temperature, wait at least 24 hours between adjustments and then recheck the temperature. To make the wine cellar colder, adjust the control to the next higher setting. To make the wine cellar less cold, adjust the control to the next lower setting. Temperature Separator (Temperature Display) The temperature separator displays the current temperatures (Fahrenheit or Celsius) for the upper and lower zones (compartments) of the wine cellar. To adjust the temperature settings, see "Adjusting Controls" earlier in this section. Dimmer Upper Lower F A B C D A. Dimmer B. Upper zone display C. Lower zone display D. Fahrenheit/Celsius Recommended Zone Storing Locations For best storing and serving temperatures for your bottle of wine, use the wine producer's recommended temperature setting. See the wine's label for details. It is recommended to store wine for short-term (few months) at 55°F (13°C). WINES ZONES White Wine Upper zone Lighter Red Wine Lower zone Red Wine Lower zone