KitchenAid KBZU122VSS Use & Care Guide - Page 17
Gas Conversions
UPC - 883049184401
View all KitchenAid KBZU122VSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
GAS CONVERSIONS For Models Equipped for Use with a 20 lb LP gas Tank NOTE: Models that are equipped for Natural gas require Gas Conversion Kit Part Number W10118099 for conversion to LP gas. Use the conversion instructions included in the kit. See "Assistance or Service" section for information on ordering. Conversion to a Local LP Gas Supply Installation of the regulator Tools and Parts for Gas Conversion Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. 1. Turn off the main gas supply valve. 2. Unplug side burner or disconnect power. 3. Disconnect 20 lb LP gas fuel tank (if present). 4. Turn off all burner control valves. 5. Remove rear cover and 2 screws. Tools needed ■ Phillips screwdriver ■ Thin flat-blade screwdriver ■ Pipe wrench ■ Pliers ■ Adjustable wrench ■ 10 mm socket and wrench or 10 mm nut driver ■ Pipe thread sealant certified for LP gas Parts supplied ■ Brass connector ■ Convertible regulator 4" W.C. Natural, 11" W.C. LP ■ Natural gas orifices IMPORTANT: Gas conversions must be done by a qualified installer. Before proceeding with conversion, shut off the gas supply to the appliance prior to disconnecting the electrical power. This kit is designed for use from sea level up to 2000 ft (609.6 m) elevation. For higher elevations contact KitchenAid at 1-800-422-1230 in the U.S.A. or call 1-800-607-6777 in Canada. WARNING 6. Use adjustable wrench to remove LP hose regulator from brass elbow. Use adjustable wrench to remove brass elbow. A B C Explosion Hazard Use a new CSA International approved "outdoor" gas supply line. Securely tighten all gas connections. If connected to LP, have a qualified person make sure gas pressure does not exceed 11" (28 cm) water column. Examples of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Failure to do so can result in death, explosion, or fire. D A. Manifold B. Brass elbow C. Rear of side burner D. Gas pressure regulator/hose assembly 7. Apply pipe sealant to the threads of the brass connector. Use pipe thread sealant that is certified for use with LP gas. 8. Use adjustable wrench to install brass connector (supplied) to manifold fitting. NOTE: The arrow on the regulator must be pointing toward the brass connector. 17